Home > CMC Hydraulic Tilt Trim Units > PT-35 Hydraulic Electric Tilt Trim Unit 52100

PT-35 Hydraulic Electric Tilt Trim Unit 52100

PT-35 Hydraulic Electric Tilt Trim Unit 52100
Item# CMC52100
$548.55
Availability: Usually ships in 2-3 business days

Product Description

PT-35 Tilt Trim Unit Features:

  • Rated for 35 H.P. and Smaller Outboard Motors.
  • Provides 5 1/2 inches of setback from the boat transom to achieve its full potential.
  • 84 degrees of tilt and trim from the transom.
  • Fabricated from 1/4 inch 6061 T6 extruded aluminum and attached with stainless steel fasteners.
  • Cannot be used with motors with clamp mounting feet or bolts that have a width of 11 inches of greater.
  • Accommodates Clamp-on or Bolt-on Motors Without the Need of an Adapter.
  • Includes up-down toggle switch.
  • The boater can then move the engine up and down as well as tilting it in and out with the power tilt and trim.
  • Easily adjustable from top or bottom.
  • All the necessary electrical components for installation are included.


    • Hydraulic System Features:
  • Totally waterproof!
  • Marine electric hydraulic system is made of 100% non-ferrous material for corrosion resistance in any water.
  • Hydraulic actuator is completely self contained with its own fluid reservoir.
  • Hydraulic tank and hoses inside the boat are not necessary.
  • 40% more lifting capacity than other transom tilt trim units on the market.
  • Quality control guaranteed by computer aided design and precision machining.

    NOTE: The inside dimension of the motor mounting area of the PT-35 is 11 inches. Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 11 inch limit. If these measurements are more than 11 inches, you will have to go to the PT-130. Mounting bolts are not included with the PT-35.

    "Outside the US country: Save on shipping. Please Email Us for a less expensive alternative to UPS."


    REMINDER:
  • All CMC Orders received from Thursday (until 1:00 P.M Central Time) to Sunday would be shipped on the next business day (Monday)

    • Accessories

    CMC Tilt Trim Gauge Conversion Kit 51207
    CMC Tilt Trim Gauge Conversion Kit 51207
  • CMC Tilt Trim Gauge Conversion Kit
  • Not use for PT-35 electric tilt trim.
  • Sealed and drip proof mounts in the dash of the boat for safe and convenient height determination.
  • The sending unit is totally fastened and water resistant, which removes any moisture problems.
  • The up-down toggle switch is standard equipment.
  • Get this item for your convenience.
  • CMC product from the highest quality materials.v
    • $223.44
    Availability: Usually ships in 2-3 business days
    CMC51207
    		CMC Transom Clamp Adapter 13022
    CMC Transom Clamp Adapter 13022
  • Use with the PT-130 for installation of motors mounted with transom clamps.
  • This adapter kit is made for quick and easy installation of these type of motors.
  • If your motor has clamps that tighten inside of the splash well, you will need to purchase this transom clamp adapter.
  • Some motors are too big for the small plate, but they need an adapter to fit on the larger plate, these are the adapter plates.
    • $72.00
    Availability: Usually ships in 2-3 business days
    CMC13022